RV125K7 (’07-MODEL) 85
INSTALLATION
Installation is in the reverse order of removal. Pay attention to
the following point:
FUEL LEVEL INDICATOR CHECK RELAY
REMOVAL AND INSTALLATION
Fuel level indicator check relay is located behind the ECM.
• Remove the right frame cover. (RV125K3 5-3)
• Remove the fuel level indicator check relay 1.
• Install the fuel level indicator check relay in the reverse order
of removal.
INSPECTION
• First check the insulation between A and B terminals with
tester. Then apply 12 V to C and D terminals, + to C and -
to D, and check the continuity between A and B.
If there is no continuity, replace the fuel level indicator check
relay with a new one.
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test ()
Gasoline is very explosive. Extreme care must be
taken. The gaskets (1 and 2) must be replaced with
new ones to prevent fuel leakage.
To Next Page