CHASSIS
5-31
REMOVAL AND DISASSEMBLY
Remove the rear wheel (Refer to page 5-24)
Remove the rear absorber mounting nuts, take off the rear
absorber, right and left..
Remove the chain case mounting screws, take off the chain
case.
Remove the swing arm pivot nut and draw out the shaft
Remove the swing arm
.
.
Pull off the cotter pin and remove the nut and bolt
Remove the torque link
.
.
Remove the chain buffer.
Remove the dust seal covers and draw out the spacers.
Draw out the bushings by the special tools.
09923-73210: Bearing remover
: Slide shaft09930-30102
To Next Page
Loading...
