CHASSIS
5-32
Inspect the bushing for wear and damage.
Using a dial gauge check the pivot shaft for runout and
replace it if the runout exceeds the limit.
,
INSPECTION
BUSHING
SWING ARM PIVOT SHAFT
09900-20606: Dial gauge (1/100)
09900-20701: Magnetic stand
09900-21304: V block-
Pivot shaft runout limit: 0.6 mm
REASSEMBLY
Reassemble and remount the swing arm in the reverse order
of disassembly and removal, and also carry out the following
steps:
Force-fit the bushings into the swing arm by using the
special tool.
Apply grease to the spacer and dust seal cover when
installing
Insert the swing arm pivot shaft from the left side, and
tighten the pivot shaft nut to specified torque.
Tighten the rear absorber nut to the specified torque.
.
09924-84521: Bearing installer set
Rear pivot shaft nut: 50~80 N•m
Rear absorber nut: 22~35 N•m
99000-25010 Super grease ”A”:
To Next Page
Loading...
