7-6 COOLING AND LUBRICATION SYSTEM
COOLING FAN
REMOVAL
• Remove the cooling fan. (7-4)
INSPECTION
• Remove the right under cowling. (8-5)
• Disconnect the cooling fan coupler .
• Test the cooling fan motor for load current with an ammeter
connected as shown in the illustration.
• The voltmeter is for making sure that the battery applies
12 V to the cooling fan motor . With the cooling fan motor
with electric motor fan running at full speed, the ammeter
should be indicating not 5 A and more.
• If the fan motor does not turn, replace the motor assembly
with a new one.
NOTE:
When making above test, it is not necessary to remove the cool-
ing fan.
INSTALLATION
• Install the cooling fan. (7-5)
To Next Page
Loading...
