2-18 PERIODIC MAINTENANCE
COOLING SYSTEM
ENGINE COOLANT LEVEL CHECK
• Keep the motorcycle upright.
• Check the engine coolant level by observing the upper and
lower lines on the engine coolant reservoir.
" Upper line # Lower line
• If the level is below the lower line, lift and support the fuel tank
(5-3), and add engine coolant to the full line from the
engine coolant reservoir filler.
ENGINE COOLANT CHANGE
• Remove the under cowlings. (8-5)
• Remove the radiator cap .
• Drain engine coolant by disconnecting the radiator hose
from the water pump.
#
• Flush the radiator with fresh water if necessary.
• Connect the radiator hose securely.
• Pour the specified engine coolant up to the radiator inlet.
Engine coolant capacity (excluding reservoir):
2 250 ml (2.4/2.0 US/lmp qt)
• Bleed the air from the engine coolant circuit in the following
procedure. (2-19)
ENGINE COOLANT INFORMATION (7-2)
Inspect every 6 000 km (4 000 miles, 12 months).
Replace engine coolant every 2 years.
* Do not open the radiator cap when the engine is hot,
as you may be injured by escaping hot liquid or
vapor.
* Engine coolant may be harmful if swallowed or if it
comes in contact with skin or eyes. If engine coolant
gets into the eyes or in contact with the skin, flush
thoroughly with plenty of water. If swallowed, induce
vomiting and call physician immediately!
To Next Page
Loading...
