Suzuki GSX-R1000 2007 - Excv Cable Replacement; Excva Inspection

EXHAUST SYSTEM 6-7
• Turn the adjuster  in or out until the thread length $
becomes the measured value before disconnecting the No.1
cable .
• Tighten the lock-nut .
• Turn the adjuster  in or out until the thread length %
becomes the measured value before disconnecting the No.2
cable .
• Tighten the lock-nut .
• Connect the EXCVA lead wire couplers .
EXCVA INSPECTION
4-66
EXCV CABLE REPLACEMENT
• Turn the ignition switch OFF.
• Lift and support the fuel tank. (5-3)
• Remove the right under cowling. (8-5)
• Disconnect the EXCV cables from the EXCVA pulley.
(6-4)

• Disconnect the EXCV cables from the EXCV pulley.
NOTE:
The EXCV cables are identified by the letters.
No.1 cable : 21H0CL
No.2 cable : 21H0OP
Before disconnecting the EXCV cables, be sure to set
the EXCVA to the ADJUSTMENT setting position.
(6-4)
21H0CL
21H0OP