PERIODIC MAINTENANCE AND TUNE-UP PROCEDURES 2-10
COOLING SYSTEM
Inspect at initial 1000 km (600 miles or 2 months) and
every 12000 km (7500 miles or 24 months).
Change coolant every 2 years.
Replace radiator hoses every 4 years.
l
Remove the right frame head cover.
l
Remove the radiator cap @ and drain plug 0.
WARNING:
Do not open the radiator cap when the engine is hot, as you
may be injured by escaping hot liquid or vapor.
Coolant may be harmful if swallowed or if it comes in
contact with skin or eyes. If coolant gets into the eyes or in
contact with the skin, flush thoroughly with plenty of
water. If swallowed, induce vomitting and call physician
immediately
!
Flush the radiator with fresh water if necessary.
Tighten the drain plug @ securely and remove the air
bleeder plug 8.
Pour the specified coolant up to the radiator inlet and
tighten the air bleeder plug 0.
Tightening torque
Coolant drain plug : 10 - 12 N-m
(1.0 - 1.2 kg-m, 7.0 - 8.5 lb-ft)
Air bleeder plug
: IO - 12 N.m
(1.0 - 1.2 kg-m, 7.0 - 8.5 lb-ft)
NOTE:
For coolant information, refer to page 5-2.
l
Close the radiator cap 0 securely.
l
After warning up and cooling down the engine, add the
specified coolant up to the radiator inlet.
CAUTION:
Repeat above procedure several times and make sure that the
radiator is filled with coolant up to the inlet hole.
Coolant capacity
:
1700 ml (1.8/1.5 US/Imp. qt)
CLUTCH
Inspect at initial 1000 km (600 miles or 2 months) and
every 6000 km (4000 miles or 12 months).
l
Loosen the lock nut @ and turn in the adjuster @all the
way into the clutch lever holder.
Classic Cycles Technical Resources
To Next Page
