Suzuki VX800L - Generator; Starter Clutch

341 ENGINE
GENERATOR AND SIGNAL GENERATOR
SERVICING
l When replacing the generator coil or signal generator coil,
apply THREAD LOCK “1342” (99000-32050) to the stator
set screws and its lead wire guide screws.
NOTE:
Wipe off oil or grease on screw completely, and then apply
THREAD LOCK “1342’:
STARTER CLUTCH SERVICING
l Hold the rotor with off-set wrench and remove the starter
clutch securing bolts.
09914-25811 :
“T” type hexagon wrench (6 mm)
l When fitting the one way clutch to the guide, position
flange side of one way clutch to the rotor side.
l Apply THREAD LOCK SUPER “1303”/“1305” to the
securing bolts and tighten them to the specified torque
while holding the rotor with off-set wrench.
(For U.S.A. model)
99000-32030 : THREAD LOCK SUPER “1303”
(For the other models)
99000-32100 : THREAD LOCK SUPER “1305”
09914-25811 : “T” type hexagon wrench
Tightening torque : 23 - 28 N-m
(2.3 - 2.8 kg-m, 16.5 - 20.0 lb-ft)
Check the operation of starter clutch by turning the starter
driven gear.
NOTE:
The gear turns one direction only.
www.ClassicCycles.org