©2022 Sveaverken. All rights reserved.
Sveaverken F100 Auto Steer System Software User Manual
adjustment, or automatic turning to prevent personal injury or property damage.
Operation
1. Do not get on or off the vehicle during operation.
2. Monitor the operation condition in real time during operation to ensure timely intervention
when necessary.
3. Drive the vehicle in the manual mode on public roads or in public places.
Inspection
1. Ensure that there is sufficient oil in the fuel tank of the vehicle.
2. Ensure that the parameter calibration is complete on the control terminal before operation.
3. Ensure that the antennas and the angle sensor are properly installed. If any is moved, calibrate it
again before use.
4. Ensure that all cables are intact. If any damage is found, stop the operation and replace the
cable.
Others
1. Disassembling the product housing without authorization may invalidate the warranty.
2. Damage caused by force majeure events, such as lightning strikes, overvoltage, and collision, is
not covered by the warranty.
3. Connect the devices strictly in accordance with this manual. When connecting cables such as
data cables, hold the end of the plug and gently plug or unplug it. Do not pull the plug by force
or twist it, which may break the pins.
4. Follow the power supply requirements for this product (system). The supply voltage for the
control terminal and the electric steering wheel is 9 V–36 V.
To Next Page
Loading...
