Sveaverken F100 - Easy Control (Optional)

69 ©2022 Sveaverken. All rights reserved.
Sveaverken F100 Auto Steer System Software User Manual
Data Type
Content
GST (GPGST)
GPS pseudorange noise statistics, including the standard
deviation information of three-dimensional coordinates.
HDT (GPHDT)
Heading angle, with true north as reference.
GGA (GPGGA)
Position information.
RMC (GPRMC)
Recommended positioning information.
VTG (GPVTG)
Ground speed information.
ZDA (GPZDA)
Time and date information.
Note:
1. To use the NMEA feature, you need to purchase the dedicated NMEA wires separately.
2. Ensure that the baud rate setting is consistent with the external device.
3. Check the data types needed by the external device and set the appropriate transfer frequency.
During the operation, ensure that the data types are enabled.
5.5 Easy Control (Optional)
Easy Control is a wireless remote control that works with Sveaverken F100 Auto Steer System. You
can use this remote control to enable or disable the autosteering operation, and control the
common features, such as marking point A and point B for guidance line creation, turning on or off
the operation data recording, and controlling the Basic U-turn.
5.5.1 Pairing
Install two AAA batteries, press and hold the two buttons at the bottom until the indicator in the
upper left corner turns solid for 3 seconds and then blinks rapidly for 60 seconds, indicating that
the remote control is ready for pairing. Go to the system settings on the control terminal to turn on
Bluetooth connection and pair with the remote control. After the successful pairing, the system
remembers the remote control and connects to it automatically in future operations.