Equipment details
100
3. The gas heating symbol goes out when the
panel returns to standby.
7. HEATING WITH ELECTRICITY
To activate heating with electricity. The greater
the power the more rapid the heating will be.
1. Press the button with the arrow until
the electrical heating symbol flashes.
The “OFF” text is shown next to the
temperature on the display.
2. Select power (1kW, 2kW or 3kW) with the
+/On or -/Off buttons. The diagram shows
that 3kW power has been selected (some
boilers are only equipped with 1-2kW).
3. The electrical heating symbol is shown
when the panel returns to standby.
Do as follows to switch off heating with
electricity.
1. Press the button with the arrow until the
electrical heating symbol flashes.
2. Switch off the electrical heating by pressing
the -/Off button until all power steps have
gone out. The “OFF” text is shown next to
the temperature on the display.
3. The electrical heating symbol goes out
when the panel returns to standby.
8. CIRCULATION PUMP
This symbol is displayed when the circulation
pump is operating (12Vpump or 230V-pump).
When heating is required in the vehicle, the
pump starts automatically.
The boiler selects the 230V pump if one is
installed in the system. When the 230V is
disconnected from the vehicle the 12V pump is
To Next Page
Loading...
