Swift Group 2011 - Page 118

Equipment details
114
container storage location remain open.
• The changing of the gas container must
be done outside in the open air and out of
reach of any possible sources of ignition.
• It is prohibited to use gas to power the
refrigerator while you are driving. If a road
accident results in fire, there is a danger
of explosion.
• You are strongly advised not to use gas to
power the refrigerator while you are driving.
If a road accident results in fire, there is a
danger of an explosion
• You are strongly advised not to use gas
to power the refrigerator in the vicinity of
petrol stations.
• Open the valve of the gas bottle and the
gas taps.
• Set the thermostat (B) to the highest level
(the biggest dot)
• Set the energy source selector switch
(A) to
• gnite the gas flame:
Manual ignition
• Press the thermostat (B), and keep
it depressed.
• Press the button for manual ignition
several times at intervals of between 1 and
2 seconds.
• Release the thermostat when the indicator
of the flame meter enters the green area. If
it does not enter the green area, repeat the
previous step.
WARNING! Never keep the thermostat
depressed for longer than 30 seconds.
If a flame does not appear, wait at least
five minutes before trying again. If you
fail to observe this rule, there may be an
accumulation of gas creating the risk of
fire or explosion.
• Set the desired refrigeration level by means
of the thermostat (B). (The bigger the dot,
the colder the setting)
Electrical ignition (illustration 6)
• Press the thermostat (B) and keep
it depressed.
• Ignition takes place automatically. You
will hear a ticking noise. If ignition was
successful, the noise will stop and the
flame meter will turn green. Release the
thermostat.
• If the flame goes out, ignition will be
repeated automatically.
• Set the desired refrigeration level by means
of the thermostat (B). (The bigger the dot,
the colder the setting)
Switching off the refrigerator
• Set the energy source selector switch
(A) to
• The refrigerator is now completely
switched off.
• Use the special storage latch on the door
locking mechanism to stop the door from
closing. This prevents unpleasant odours
and mould in the refrigerator.
Important! If you are not going to use
the refrigerator for a prolonged period,
close the valve of the gas bottle and the
gas taps.
Premium LCD refrigerator operation (control
panel, illustration 7)
A = Main switch (on/off)
B = Mode selection switch
C = cooling level switch
D = Display LED
• It is recommendable to clean the inside
of the refrigerator before you switch on
the refrigerator.
• Let the refrigerator run for at least eight hours
before you place food in it for the first time.