25 - 36
6. Trouble Shooting
6.1 Trouble Shooting
SYLVAC Scan gauging systems have been designed for ease of use and trouble-free operation. This
section details problems that might occur at start-up and also a list of error messages which can be
reported by the system when running.
6.2 Start-Up Problems
1. System shows no signs of life:
- check the power source and connections, including to the computer and monitor.
- check the computer and monitor are switched on.
2. Computer starts but the illumination does not light:
- check the cable connection.
- replace the LED.
3. System starts but will not calibrate:
- clean the setting piece with a clean, dry cloth.
- check that the setting piece is located correctly in the tooling.
- check that the setting piece serial number requested matches that being used.
To Next Page
Loading...
Need help?
General
