5-1
Rev 2.2, 10/31/94
5. Rear Panel Overview
S/PDIFS/PDIF
PHANTOM
BYPASS
+48V
POWER
MIC INPUT
LINE INPUTAES/EBU BALANCED OUT R BALANCED OUT L
DIGITAL
INPUT
S/PDIF
AES/EBU
S/PDIF
DIGITAL
OUTPUT
AES/EBU
INPUT
MIDI
OUTPUT
MIDI
THIS UNIT CONTAINS NO
USER SERVICEABLE PARTS.
POWER
20W MAXIMUM
MANUFACTURED IN THE USA BY
AES/EBU
SSERP ESSPRESSPR
Serial Number Do yourself a favor and write this number down
somewhere safe, and while you're at it, please send
us the completed warranty card.
AC Power Input IEC-power connector. Connect only to appropriate
AC power source. Refer to actual rear-panel
marking for correct AC source value.
POWER switch Push-push switch turns the 601 on and off.
MIDI connectors 5-pin DIN connectors used for MIDI output and
input.
DIGITAL OUTPUT RCA connector and XLR-male connector used for
S/PDIF and AES/EBU (respectively) digital output.
Push-push switch selects between protocols.
DIGITAL INPUT RCA connector and XLR-female connector used for
S/PDIF and AES/EBU (respectively) digital input.
Push-push switch selects between protocols. All
connectors transformer isolated.
Outputs XLR-male, balanced. Analog audio output of the
601. Pin 2 is hot.
Inputs XLR-female, balanced. Line level and microphone
level analog inputs. Pin 2 is hot.
Phantom Power Push-push switch enables (in) or disables (out)
+48V phantom power at microphone input for
remotely powering condenser microphones.
Additional information on phantom powering can
be found in Chapter 3 and in the References.
To Next Page
Loading...