Synrad 32-1 - Page 25

SYNRAD® 32-1 Operator’s Manual Version 2.2
25
Laser Safety
SYNRAD® 32-1 lasers have demonstrated performance characteristics that have met or ex-
ceeded the requirements of EMC Directive 2014/30/EU.
When integrating SYNRAD 32-1 OEM lasers, the Buyer and/or integrator of the end system is
responsible for meeting all applicable Standards to obtain the CE mark. To aid this compliance
process, SYNRAD testing program has demonstrated that 32-1 lasers comply with the relevant
requirements of 2014/30/EU, the Electromagnetic Compatibility Directive, as summarized in
the table below.
Table 2-2 European Union Directives.
Applicable Standards / Norms
2014/30/EU Electromagnetic Compatibility Directive
2014/35/EU Low Voltage Directive
2011/65/EU RoHS Directive
EN 61010-1:2010 Safety Requirements for Electrical Equipment for Measure-
ment, Control, and Laboratory Use - Part 1: General
Requirements
EN 61000-6-4:2007 Radiated Emissions Group 1, Class A
EN 61000-6-4:2007 Conducted Emissions Group 1, Class A
EN 61000-6-2:2005 Electrostatic Discharge Immunity
EN 61000-6-2:2005 RF Electromagnetic Field Immunity
EN 61000-6-2:2005 Electrical Fast Transient/Burst Immunity
EN 61000-6-2:2005 Conducted RF Disturbances Immunity
After a laser or laser processing system has met the requirements of all applicable EU Direc-
tives, the product can bear the ocial compliance mark of the European Union as a Declara-
tion of Conformity.
After a laser or laser processing system has met the requirements of all applicable EU Direc-
tives, the product can bear the ocial compliance mark of the European Union as shown in
the gure below and a Declaration of Conformity is provided for the compliant component.
Figure 2-4 European compliance mark.