Taco SKV SelfSensing

Taco® SKV
31
302-365, Effective: June 5, 2017
© 2017 Taco, Inc.
Manual Initialization
1.Remove power to the unit and wait for the display
to turn off.
2.Press and hold [Status], [Main Menu], and [OK] at
the same time and apply power to the unit.
Factory default parameter settings are restored during
start-up. This may take slightly longer than normal.
Manual initialization does not reset the following adjust-
able frequency drive information:
• 15-00 Operating Hours
• 15-03 Power-ups
• 15-04 Over Temps
• 15-05 Over Volts
9.3 Password Protection
9.3.1 Enable Password Protection for
Main Menu
1.Press [Main Menu].
2.Select 0-** Operation / Display by pressing [OK].
3.Scroll Down to parameter 0-6* Password.
4.Press [OK].
5.Scroll down to parameter 0-61 Access to
Main Menu w/o Password.
6.Press [OK].
7.Change parameter 0-61 to “[2] LCP: No Access.”
8.Press [OK].
The Main Menu is now password protected. The default
password is 100.
9.3.2 Disable Main Menu Password
1.Follow steps 1-6 in section 9.3.1 above.
2.Change parameter 0-61 to “[0] Full Access.”
3.Press [OK].
The Main Menu Password is now disabled.