Taie FU96 - Auto Tuning Execution; PID Value Setting

9.5 ON/OFF Control Setting
PV
PV
Hold key 3 seconds,
then entering into LEVEL_2,
1.
SV
Display after power-on. 2. as upper display shows “P1”,
SV
with lower display showing
current P1 value.
PV
When key is pressed,
PV
Press key until
3. the lower display flashes, 4.
SV
P1 = 0.0
upper display.
SV
PV
PV
5.
wohs litnu yek sserPwen erots ot yek sserP
SV
6.
value.
“HYS1”。
SV
PV
PV Press key and
7.
When key is pressed,
SV
8.
key to set the intended HYS1
the lower display flashes.
SV value.
PV
Heat mode formula:
Press key to store new
PV > (SV + HYS1) → OUT1 OFF
9.
SV
PV ≤ (SV - HYS1) → OUT1 ON
value. Cool mode formula:
PV ≥
(
SV + HYS1
)
→ OUT1 ON
PV < (SV - HYS1) → OUT1 OFF
9.6 Alarm Mode Setting
PV
Hold key + key 3
PV
seconds, then entering into
1. Display after power-on. 2.
LEVEL_3 upper display
SV showing “INP1” with lower
SV
display showing current input
type.
PV
Press key until show
PV
When key is pressed,
3.
4.
SV
“ALD1”。
the lower display flashes
SV
PV
Press key and
PV
Press key to store new
5.
value of ALD1.
SV
key to set the intended ALD1 6.
※ Please refer to ch12.1
value.
SV
Alarm mode.
9.7 Alarm Value Setting
PV
PV
Press key until show
1. Display after power-on. 2.
SV
“AL1”。
SV
PV
When key is pressed,
PV
Press key and
3. 1LA dednetni eht tes ot yek .4
SV
the lower display flashes.
SV
value.
PV
5.
SV
Press key to store new value of AL1.
FY/FU operation manual 18