Taie FU96 - Manual Mode Selection

9.8 Manual Mode Selection
PV
PV
2 seconds. 1.
SV
dloH.2 .no-rewop retfa yalpsiD
SV
PV
When key is pressed,
PV
Press key and
3. 4. key to set the intended
SV
the lower display flashes.
SV
output% value.
PV
In manual mode OUTL=100.0，output=100.0 %
5.
SV
Press key to store new continuously.
value.
In manual mode OUTL=20.0，output=20.0 %
continuously.
10. Flow Chart of Parameter Setting
10.1 Level Operation Mode
1. LEVEL 1 enter to the LEVEL 2
Hold SET key for 3 seconds then entering into LEVEL 2
2. LEVEL 1 enter to the LEVEL 3
Hold SET key + SHIFT key for 3 seconds then entering into LEVEL 3
3. LEVEL 2 return to the LEVEL 1
Hold SET key for 3 seconds then return to LEVEL 1
4. LEVEL 2 enter to the LEVEL 3
Hold SET key for 3 seconds then entering to LEVEL 3
5. LEVEL 2 enter to the LEVEL 4
On the LEVEL 2 then press SET key to find parameter “LCK
modify LCK value from current value to 1111
after hold SET key + SHIFT key 3 seconds entering into LEVEL 4
6. LEVEL 3 return to the LEVEL 1
Hold SET key + SHIFT key for 3 seconds then return to LEVEL 1
7. LEVEL 3 return to the LEVEL 2
Hold SET key for 3 seconds then return to LEVEL 2
8. LEVEL 4 return to the LEVEL 1
Hold SET key + SHIFT key for 3 seconds then return to LEVEL 1
9. LEVEL 4 return to the LEVEL 2
Hold SET key for 3 seconds then return to LEVEL 2
19 FY/FU operation manual