Taie FU96 - Dehumidification Function

Notes
1. ANL2 & ANH2 is the current signal calibration parameters. It has been calibrated before leaving the factory.
Do not change this parameter value.
2. The user only needs to set HBAC, the rest of the parameters will be set & calibrated at the factory.
3. CT has two specifications: SC 80-T & SC 100-T. Please check heater wire diameter and specify required CT.
CT Specifications
snoitacificepS metI
Model numbe
r
T-001 CST-08 CS
Max. continuous current 80A 100A
%5 %3 ycaruccA
mm6.21mm9.5 erutrepA
Dieiectric Withstanding Voltage(Hi-pot) 2500Vrms / 1 minute 4000Vrms / 1 minute
s/m 89 ,ZH 05 ecnatsiser noitarbiV
2
g 03 .xorppAg 21 .xorppA thgieW
Dimensions (UNIT：mm)
SC 80-T
SC 100-T
FY/FU operation manual 36