TallyGenicom 2248 - Page 112

USING SETUP MODE
User's Manual5-38
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST
Items
<CNT-LFT> Fine-tunes the left print start
position for continuous forms.
–10/90, ...,
0/90, Moves the position left or
..., 10/90 right in increments of 1/90
inch (0.28 mm).
<CUT-LFT> Fine-tunes the left print start
position for single sheets.
–10/90, ...,
0/90, Moves the position left or
..., 10/90 right in increments of
1/90 inch (0.28 mm).
<CUT-ADJ> Compensates the line spacing
pitch on the basis of the
spacing error accumulated for
feeding single sheets by10
inches.
Decreases or increases in
increments of 1/360 inch in
total.
<CSF-ADJ> Compensates the line spacing
pitch on the basis of the
spacing error accumulated for
feeding single sheets by10
inches.
Decreases or increases in
increments of 1/360 inch in
total.
This option is available only
when paper is being loaded in
the cut sheet feeder.
Options Description
–21/360, –14/360,
–7/360,
0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)
–21/360, –14/360,
–7/360,
0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)