4.7 VISCA Command List
Command List (1/2)
Initial Value
Factory Default
Address Setting. Supports daisy chain addressing a nearest camera (x=1 to 7).
Power off (standby mode: VISCA commands are acceptable)
pqrs: Zoom Position: 0000h - 4000h
Digital Zoom On
DZoomPos: 4000h-7C00h (1x=4000h, 2x=6000h, 4x=7000h, 8x=7800h, 12x=7A80h, 16x: 7C00h)
pqrs: Focus Position: 1000h (far) - B000h (near)
Execute whole focus range (Near~Inf) scan. At AF mode, after scan, AF operation continues
Scan by wobbling, execute only at MF mode
pqrs: Focus Near Limit Position
AF Movement Mode: Interval
AF Movement Mode: Zoom Trigger AF
pq: Movement Time, rs: Interval Time (second)
Focus correction for no IR Light
Focus correction for IR Light
CAM_VibrationCompensation
EIS (Electronic Image Stabilization) On
Same FOV as VC On, but VC Off
pqrs: Zoom Position, tuvw: Focus Position
Zoom: 0000h - 4000h, Focus: 1000h (far) - B000h (near)
One push WB mode. Reproduce WB of the last calculation by One Push Trigger
Manual Control Mode (enable to set R gain and B gain)
One Push WB Trigger. Calculate WB of current image that can be used at One Push WB
Manual Control of R Gain at Manual WB mode
pq: R Gain at Manual WB mode
Manual Control of B Gain at Manual WB mode
pq: B Gain at Manual WB mode
Slow shutter On/Off: Enabled at AE full auto or iris priority mode
Shutter Setting: Enabled at AE manual mode or AE shutter priority mode
pq: Shutter Position: Enabled at AE manual mode or AE shutter priority mode
Iris Setting: Enabled at AE manual mode or AE shutter priority mode
pq: Gain Position: Enabled at AE manual mode or AE shutter priority mode (00h - 1Ch)
pq: Gain Position: Enabled at AE auto, shutter priority or iris priority mode (04h - 1Ch)
Exposure Compensation On/Off: Enabled at other mode than AE manual mode
Exposure Compensation Amount Setting: Enabled at CAM_ExpComp On
pq: ExpComp position: Enabled at CAM_ExpComp On
Back Light Compensation On/Off: Exclusive to SpotAE. Can be used at SpotAE Off
Spot AE Setting: Exclusive to BackLight. Can be used at BackLight Off
pq: X(00h-0Fh), rs: Y(00h-0Fh)
pp: AE Response Setting (01h-30h), default value: 10h
Wide Dynamic Range On/Off
p: 0: mid, 1: low, 2: mid, 3: high
pq: Aperture Gain 00h-0fh
p: 3DNR Setting (0h:Off, 1-5: Level)
q: 2DNR Setting (0h:Off, 1-5: Level)
p: Gamma Setting
(0: Standard, 1: Straight, 2: Low noise (Narrow dynamic range), 3: Wide dynamic range)
Picture Flip (upside-down & mirror) On
Picture Flip (upside-down & mirror) Off
pq: ICR On -> Off threshold level (00h - 1Ch)
Auto ICR Switch Alarm On/Off
Start up in this mode when the power is turned on
To Next Page
Loading...