Tandy 1000 MS-DOS User Manual

,.,
!
r-
I
VOL (Volume)
1 VOL [drive:]
Chapter 6 / Command Reference
Internal
Displays the volume label of the disk in the specified drive. (You
r can assign a label by using the IV parameter in the FORMAT
!- command.) If the disk does not have a volume label, VOL
displays:
~ Volume in drive n has no label
Parameters
drive: indicates the disk for which you wish to display the label.
If you omit the drive, MS-DOS displays the volume label of the
current disk.
r
L.
r
,
r
L
...
l
~
i
Notes and Suggestions
• Enter the VOL command whenever you forget a volume label.
Example
vol b: I ENTER I
MS-DOS displays a message similar to this:
Volume in drive B is DISKONE
vo 1 I ENTER I
displays the volume label of the current disk.
185

Tandy 1000 MS-DOS Specifications

General

Brand	Tandy
Model	1000 MS-DOS
Category	Desktop
Language	English