Taylor C712 - Service Manual

Other manuals for Taylor C712

Operating Instructions57 pages

Operator Training41 pages

Operator's Manual61 pages

Questions and Answers:

A
Alan MyersAug 26, 2025
What to do if the product from my Taylor C712 is too soft?
- L
  Linda CurryAug 27, 2025
  If your Taylor Freezer is dispensing product that is too soft, consider the following possible causes: * Insufficient air space around the machine. Ensure a minimum of 3” clearance on all sides and install the deflector. * Worn scraper blades. Replace the scraper blades. * Dirty air-cooled condenser. Clean monthly. * Outdated mix. Use fresh mix. * Refrigerant shortage. Locate and repair the leak. * Product viscosity set too warm. Adjust the product viscosity. * Incorrect usage of the mix feed tube (C713). Follow the correct feed tube procedures and use of the air orifice.
S
Samantha LongAug 25, 2025
Why is the head pressure too high in my Taylor Freezer?
- Z
  Zachary LoganAug 26, 2025
  If the head pressure of your Taylor Freezer is too high, it could be due to several reasons: * The condenser might be dirty; if so, clean it. * The water valve might be out of adjustment or restricted; if so, check the adjustment and the water supply. * There might be insufficient air space around the machine; if so, ensure sufficient air space. * There might be a refrigerant overcharge; if so, correct the refrigerant charge. * The blower might be faulty; if so, replace the blower.
K
Kristina SullivanAug 23, 2025
Why does my Taylor Freezer run long cycles and shut off on the safety timer?
- M
  mendozajohnAug 23, 2025
  If your Taylor Freezer is operating for extended periods and cycling off on the 11-minute safety timer, the issue could stem from several factors: * A dirty condenser. Clean the condenser. * Worn scraper blades. Replace the scraper blades. * A shortage of refrigerant. Repair the leak and recharge the machine. * Air in the system. Purge and recharge the system. * High overrun product (C712). Check the pump operation for the correct air/mix ratio.