Taylor PH61 User Manual

TROUBLESHOOTING GUIDE
8-3
Burger King PH61
Troubleshooting Guide
8
12.Excessive mix leakage
into the long drip pan.
a. The seal on driveshaft is
improperly lubricated or worn.
a. Lubricate properly or replace the seal.
b. The seal is installed inside out on
the driveshaft.
b. Install correctly.
c. Worn or missing O-rings on pump
driveshaft.
c. Install or replace the O-rings.
d. Inadequate lubrication of the
driveshaft.
d. Lubricate properly.
e. The driveshaft and beater
assembly worked forward.
e. Call a Taylor service technician.
f. Worn rear shell bearing. f. Call a Taylor service technician.
g. Gearbox is out of alignment. g. Call a Taylor service technician.
13.The driveshaft is stuck
in the drive coupling.
a. Mix and lubricant collected in drive
coupling.
a. Brush-clean the rear shell bearing area regularly.
b. Rounded corners of driveshaft,
drive coupling, or both.
b. Call a Taylor service technician.
c. Gearbox is out of alignment. c. Call a Taylor service technician.
14.Freezing cylinder walls
scored.
a. Missing or worn front bearing. a. Install or replace the front bearing.
b. Broken beater pins. b. Repair or replace the beater assembly. When
installing scraper blades, make sure they are
properly attached over the pins.
c. Gearbox is out of alignment. c. Call a Taylor service technician.
15.Spinner shaft will not
rotate to blend mix and
syrup.
a. Flexible coupling is broken. a. Call a Taylor service technician.
b. Pin is missing in quick disconnect
of spinner coupling.
b. Call a Taylor service technician.
c. Spinner motor is out on thermal
overload.
c. Allow the spinner motor to cool. Also check
lubrication on spinner shaft. Properly align the motor
and lubricate properly.
16.Large adjustments are
necessary to receive 
1 oz. (30 ml) in 
5 seconds.
a. The pump tube has collapsed. a. Replace the pump tube.
b. Syrup lines are not matched with
correct syrup flavor.
b. Match the color wrapped syrup lines to the correct
syrup flavors.
c. The plunger is sticking in the syrup
valve.
c. Clean the valve.
d. Plugged syrup line fitting at freezer
door connection.
d. Clean the syrup line fitting.
e. Verify that the proper syrup
selection was made.
e. Make the proper syrup selection.
17.Pump will not operate in
the Pump mode.
a. Pump motor is not activated. a. Push the reset button.
b. The membrane switch is defective. b. Call a Taylor service technician.
Problem Probable Cause Corrective Action

Taylor PH61 Specifications

General

Brand	Taylor
Model	PH61
Category	Freezer
Language	English