Taylor Wawa C708 - Hopper Temperature Too Cold Troubleshooting; Mix Level Probe Issues; Mix Leakage from Door Spout; Driveshaft Stuck Troubleshooting

TROUBLESHOOTING GUIDE
8-3
Model C708 - WAWA
Troubleshooting Guide
8
13. Excessive mix leakage
into the long drip pan.
a. The seal on driveshaft is
improperly lubricated or worn.
a. Lubricate properly or replace the seal.
6-1
b. The seal is installed inside out on
the driveshaft.
b. Install correctly.
6-1
c. Inadequate lubrication of the
driveshaft.
c. Lubricate properly.
6-1
d. The driveshaft and beater
assembly worked forward.
d. Call a service technician.
- - -
e. Worn rear shell bearing. e. Call a service technician. - - -
f. Gearbox out of alignment. f. Call a service technician. - - -
14. The driveshaft is stuck
in the drive coupling.
a. Mix and lubricant collected in the
drive coupling.
a. Brush-clean the rear shell bearing
area regularly.
6-16
b. Rounded corners of driveshaft, the
drive coupling, or both.
b. Call a service technician.
- - -
c. Gearbox is out of alignment. c. Call a service technician. - - -
15. The freezing cylinder
walls are scored.
a. Missing or worn front bearing and
beater shoes.
a. Install or replace the front bearing and
beater shoes.
6-3
b. Scraper blades are damaged. b. Replace scraper blades. 6-2
c. Machine was placed in Auto mode
before all sanitizing solution was
removed from freezing cylinder.
c. Place machine in Auto mode only
after priming is complete and all
sanitizing solution is removed.
6-14/6-11
d. Broken freezer door baffle rod. d. Replace freezer door. - - -
e. Broken beater pins. e. Replace beater assembly. 6-5
f. Beater assembly is bent. f. Replace beater assembly. 6-5
g. Gearbox is out of alignment. g. Call a service technician. - - -
16. The product makes a
popping sound when
drawn.
a. Draw rate is set too fast. a. Adjust draw rate of 5 oz. to 7-1/2 oz.
(142 g to 213 g) of product by weight
in 10 seconds.
5-3
b. Pump assembled incorrectly. b. Assemble and lubricate according to
instructions in this manual.
6-6
c. Freezing cylinder not primed
correctly.
c. Drain the freezing cylinder and
reprime the machine.
6-10
Problem Probable Cause Remedy
Page
Ref.