Setup
VL3X – Reference manual (updated 2015-07-16) 182
FOOTSW MODE parameters
Use the (three or six) Mode parameters below
the FOOTSW parameters to set the operation
modes of the footswitches on a TC-Helicon
Switch-3 or Switch-6 connected to your VL3X.
► Latched: Tap the footswitch on your Switch-3
or Switch-6 to activate the assigned effect,
tap it again to deactivate it.
► Momentary: The assigned effect is on only
when you hold down the footswitch.
For more information, see “Change a button
from Latched to Momentary mode”.
To Next Page
Loading...
