TC-Helicon VL3X User Manual

Setup
VL3X – Reference manual (updated 2015-07-16) 181
FOOTSW-1 to FOOTSW-3 or
FOOTSW-1 to FOOTSW-6
parameters
These parameters are only available when the
Footswitch jack parameter has been set to
Switch-3 or Switch-6.
FOOTSW parameter settings
Each Switch-3 or Switch-6 footswitch can be as-
signed to one of the following controls:
► STEP
► PITCH COR(rection)
(Global in SETUP, not HardTune)
► ALL MUTE
► µMod
► Delay
► Reverb
► Voc(al) HIT
► Double
► Harmony
► Transducer
► HardTune
► Rhythmic
► Stutter
► Choir
► Synth
► Harm(ony) Hold*
► Set Key
► Tap Tempo
► Bypass
► G µMod (G = Guitar)
► G Delay
► G Reverb
► G HIT
► G Comp(ressor)
► G Drive
► G Amp
► G Rhythm
► G Octaver
► G Wah
► G Mute
► ALL HIT
► Go Looper (enter looper Layer)
► Loop Input
► Tuner
► 1But(ton)Looper
► LPlayRec (Looper Play Record Overdub)
► LStopErase (Loop Stop Erase)
► Loop Undo
► L(oop) Erase All
► Loop Trigger A-H
► Track Start
► Track Stop
► Track Forward
► Track Backward
► Seq Rec (Sequence Recording)
► Seq Undo (Sequence Recording Undo)
* Harmony must be active for this to have an ef-
fect.
** Toggles the Loop/Backing Track Layer. You
may find this a more convenient way of enter-
ing the Loop Layer quickly, compared to hold-
ing the Layer button.
Loop Controls on Switch-3 and Switch-6
If you have connected an (optional) Switch-3 or
Switch-6 to your VL3X, you can use it to control
some functions for Track A of the Looper.
For more advanced interaction with the Looper,
we still recommend using the Loop Layer, since
the user interface changes contextually based
on actions you perform.
Keep in mind that loop controls assigned to
Switch-3 oder Switch-6 still adhere to the op-
tions for the currently active Loop Slot, like Sync,
MET, Input etc.

TC-Helicon VL3X Specifications

General

Brand	TC-Helicon
Model	VL3X
Category	Music Equipment
Language	English