VL3X overview
VL3X – Reference manual (updated 2015-07-16) 36
Stereo vocals and a guitar amplifier
This setup is great if you have got a guitar amp
and want to send VL3X’s guitar sounds to that
amp instead of to the PA.
You may want to make a quick adjustment to the
guitar output if you are connected to an amp.
It might be desirable to turn off VL3X’s speaker
simulations while preserving all of the other gui-
tar effects. This will allow the “character” of your
amp to stay the same from Preset to Preset.
Follow the instructions in “Stereo PA connection
for vocals (and guitar if applicable)” to change
your output mode to Stereo.
Turning speaker simulation off
► Press Setup.
► Use the < or > Arrow buttons to move to the
Guitar tab.
► Use the Control Knob to move the selection
bar until Speaker Sim Enable is highlighted.
► Turn the Mix Knob directly below the dis-
play until the setting for Speaker Sim Enable
changes from On to Off.
► Press Home to exit.
Turning speaker simulation off
For Mono vocals via the PA and guitar sounds
via a guitar amplifier, follow the diagram above,
but connect only the Left XLR output from VL3X
to your PA and set the output mode to Mono.
To Next Page
Loading...
Need help?
General
