TCL TCA-60HRA/DV3O - Page 47

DC Inverter Air
Insert the anchor bolts in to the drilled holes, and drive the pins
completely into the anchor bolts with a hammer.
2.Drilling holes for anch or bolts and installing the anchor blots(m10)
According to the position of the hole, install two expansible anchor bolts(A and B) at the position shown in
the figure.
NOTE:
Co olling
1 8 000
2 4 000
36 00 0
48 000
60 000
Ca pacity
Dim ension
B tu /hr
B tu /hr
Btu / hr
Btu /hr
Btu / hr
L
98 0mm
9 80mm
12 00mm
1560mm
1560mm
With a concrete drill, drill two 10mm diameter holes at the position(A and B)
on the w all.
Insert the a nchor bolts in to the drilled holes, and drive the pins completely into the anchor bolts wit h a hammer.
47/ 113