DC Inverter Air
Display function declaration :
LED light the state of running light
When powered‐on the first time, the running light twinkles, while the double‐8 does not lit.
When started‐up normally, the running light lights on, while the double‐8 shows the designed temperature.
When operated normally, the running light lights on, while the double‐8 shows the designed temperature.
When closed down, both LED and double‐8 are gone out.
LED light the state of Timing light
When timing set, the timing light lights on, and the double‐8 flash shows the time setting within 5 seconds, then
shows the designed temperature.
When without time setting, the timing light gone out, while the double‐8 back to the original state.
LED light the state of defrosting/preheat light
When in the state of defrost, oil return, cold‐wind proof, the defrosting/preheat light lights on, while the double‐
8 shows the designed temperature. (One‐driven‐one does not show the oil return state).
When out of the state of defrost, oil return, cold‐wind proof, the defrosting/preheat light gone out, while the
double‐8 shows the designed temperature. (One‐drive‐one does not show the oil return state).
LED light the state of warning light
When double‐8 shows E* or P*, the running lights gone out, while the warning light lights on.
1.3. Duct
1) Display the faults through the remote‐control receiver indicator light of indoor unit. The faults of indoor
unit are displayed as follows:
Display function declaration:
LED light the state of running light
78/ 113
Manual SwitchN ixi e t u b e R u n n i ng l ig h t Tim in g l ig h t
D e f ro s t in g /
p re h e a t lig h t
w a r n i n g l ig h t
To Next Page
Loading...
Need help?
General
