6. STEERING SYSTEM
- 89 -
6.1.6 ASSEMBLING WHEEL
Put the tube and ap into the tire and assemble the rim paying attention to the following:
Notes: 1. Align the air valve with the notch of the rim, directing the valve to the outside of the truck.
2. Assemble the rim so that the head of the rim mounting bolt is located at the outside of the
truck.
3. Make sure that no one is at the tire side (bead side) while lling air into the tire.
4. When the air pressure becomes approx. 98 kPa {1 kgf/cm
2
} [14.2 pis], tap the all sides of
the tire with a mallet to t the tube and ap with the rim.
1. TIRE
2. TUBE
3. FLAP
Conguration of Rim Construction Bolt
4. RIM (INSIDE)
5. RIM (OUTSIDE)
6. MOUNTING BOLT
Fig. 6.10 Assembling Wheel
To Next Page
Loading...
