, Inc. (405 Essex Road, Neptune, N.J. 07753), warrants that the unit is free from defects in
material or workmanship for a period of ONE YEAR from the date of initial shipment.
at its option, repair or replace parts which prove to be defective. This will be done free of charge during
the stated warranty period. This warranty excludes defects resulting from mi
use, unauthorized modification,
operation outside the environmental or
safety specifications of the power supply, or improper site preparation or
maintenance. The customer shall contact
, for warranty service or repair as described in
the RETURNING EQUIPMENT section. The customer shall prepay shipping
charges. If the unit is covered under the
shall pay the return shipping charges.
The “WARRANTY”, “CLAIM FOR DAMAGE IN SHIPMENT”, and “RETURNING EQUIPMENT” i
equipment purchased directl
. End users receiving equi
should consult the appropriate service organization for assistance with these issues.
THIS LIMITED WARRANTY IS IN LIEU OF, AND
ALL OTHER WARRANTIES, STATUTORY, EXPRESS OR IMPLIED, INCLUDING, WITHOUT LIMITATION, ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OR OF CONFORMITY TO
All test and measuring equipment used by
for Final Acceptance Testing are traceable to
primary standards certified by the National Institute of Standards and Technology.
All power supplies contain hazardous voltage and energy. The power supply must
only be operated by qualified
personnel who have read this operator’s manual and are familiar with the operation, hazards and application of the
power supply. Proper care and jud
ment must always be observed.
Before connecting input AC power, ensure all c
overs are in place and securely fastened. E
safety ground to chassis is installed and sufficient cooling is su
Proper grounding from the input AC power is required to reduce the risk of electric shock, and to comply with
ncy and code requirements.
Use extreme caution when connecting input AC power. Only apply the input voltage specified on the rating label.
Use extreme caution when connecting any high voltage cables. Never handle any output c
After a power supply is switched OFF, its output section will retain a charge which may be lethal. Allow sufficient
discharge before handling anything connected to the output. The di
charge time specified in the
include extra time required to discharge the energy stored in the user’s load.
When user serviceable fuses are present, always replace fuses with the same type and Volt/Amp ra
Never attempt to operate the power supply in any manner not described in
Never remove DANGER or WARNING labels from the power supply. Replace lost or damaged labels
Customer Service for replacement labels.
The power supply may be serviced only by
ctory qualified service personnel.
Breaking the warranty seal will void the warranty. Prior to opening the power supply, contact
Customer Service for a written Service Waiver and a replacement warranty seal.
To Next Page
Loading...
