TDK-Lambda 802 Series - Figure 9 802 S Rear Panel; Rear Panel Layout (S Models)

25
83488001 Revision N
5.15.9. AC Input Terminal (Ref 9)
Main AC input power terminal block see section 4.4 for further details. For 200-
240VAC connect three phases and ground. For 380-440VAC option connect three
phases, Neutral and Ground. AC input is not phase rotation sensitive.
5.16. Rear Panel Layout (S Models)
The 802S rear panel is similar to the 802L except these is no SLAVE or INHIBIT BNC
connector. If a number of units are to be connected in parallel, a daisy chain type ribbon
cable should be used to connect the supplies together. See section 6.4 for more details.
Note:
The numbers in Figure 9 refer to Table 5.
Figure 9 802S Rear Panel
1
4
2
!
L1 L2 L3 N
5
6
8
9