Teac AG-V3050 - Page 9

Caution:
To avoid damaging the speakers by inputting a
sudden high-level signal, be sure to switch the power
off before connecting the speakers.
Connect each speaker to the corresponding speaker
terminals, as desired. For “Speaker Installation", refer
to page 21.
Notes:
@
When
using
the
rear
speakers,
be
sure
to
connect
them
to
both
channels
(L
and
R).
If
a
speaker
is
connected
to
only
one
channel,
no
sound
will
be
heard.
@ Use speakers with a nominal impedance of 8 ohms
or more.
Connect the speaker cords to the speaker terminals as
shown in the following illustration.
Press the lever, insert the stripped end of the
cord, then release the lever so that the cord is
held securely.