- 106 -
EO3-11070B
MA-1650-4 SERIES
HOURLY RANGE SETTING (Submode 7) (for report purposes)
CONDITION After Hourly Range Reset
OPERATION Mode Lock: SET
7 [X] |Hour| |Minute| [#] [AT/TL]
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-14-1994 MON #1
P07
08:00TM
12:00TM
15:00TM
19:00TM
0036
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-14-1994 MON #1
P07
00:00TM
0034
➤
➤
➤
Enter the time that ends
each hourly range, in
the 24-hour system.
Repeat until all the hourly ranges are
entered. (max. 24 hourly ranges)
(After a RAM Clear, no Hourly Ranges are set as Initial data.)
NOTES:
1. A maximum of 24 hourly ranges
can be set.
2. To change the table of hourly
ranges once set, partially or en-
tirely, do the entire setting op-
eration over again.
3. To reset the hourly range table
once set, operate:
Mode Lock: SET
7 [X] 0 [#] [AT/TL]
Then no hourly range sales data
will be outputted on the reports.
4. Do not set an hourly range
across 24:00, such as “from
23:00 to 1:00”. If set, no data will
be processed into that hourly
range.
5. If a time value of more than
24:00 is set, no error results. But
the sales data will not be pro-
cessed in this case.
ex.) To reset the hourly range table that has been programmed:
Mode Lock to SET, enter 7, depress [X].
Enter 0, depress [#].
Depress [AT/TL].
ex.) To set the following hourly range table:
TABLE KEY OPERATION
Mode Lock to SET.
Enter 7, depress [X].
1) up to 8:00* Enter 800, depress [#].
2) 8:00 to 12:00 Enter 1200, depress [#].
3) 12:00 to 15:00 Enter 1500, depress [#].
4) 15:00 to 19:00 Enter 1900, depress [#].
* (The first hourly range is Depress [AT/TL] to end this
automatically continued submode.
from 19:00 of the preceding
day.)
To Next Page
Loading...
