- 5 -
EO3-11070
MA-1650-4 SERIES
4. RTR DECLARATION, TERMINAL DESIGNATION
4.1 RTR (Register-to-Register) DECLARATION
By depressing the [RTR] key on the Master Terminal, various in-line jobs (DLLs, Consolidated Read/Reset Report
takings, etc.) can be performed.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET, X, Z, or MGR
Depress [RTR]
NOTES: 1. While a PC job is under way (a command of ULL, DLL, or Read/Reset from the PC), this RTR
Declaration is not possible. Similarly, while this RTR Declaration is on, no PC jobs are possible.
2. While the RTR Declaration is on, no transaction entries in REG, MGR, or - mode are possible.
3. While the RTR Declaration is on, no Backup Data Check is performed.
4. While the RTR Declaration is on, the following are jobs to be allowed:
• Programming Operations
• DLL Operations (DLL to Satellite Terminals)
• Consolidated Read/Reset Report takings
• Manual Copying of Backup Data
5. The [RTR] key can be programmed to require Manager Intervention in Key Status Programming
(Submode 23).
6. If the option “Auto Data Copying feature” is selected for Copying of Backup Data, the RTR
Declaration is not possible while a backup data update process is under way.
7. If the option “Compulsion of Data Sending to PC” is selected, the RTR Declaration is not possible
until sending the reset data (the consolidation data) to PC is completed.
4.2 RTR DECLARATION CANCEL
By depressing the [RTR] key on the Master Terminal when the RTR Declaration is on, the RTR Declaration ON
status is canceled.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET, X, Z, or MGR
Depress [RTR]
NOTE: If the Backup Error Flag is ON (the standard error message is “PLEASE BACK UP”), it means that
manual copying of Backup Data is required, and therefore the RTR Declaration Cancel is not accepted
until copying is completed.
To Next Page
Loading...
Need help?
General
