TEC MA-1650-4 Series - Direct Character Entry Method

- 25 -
EO3-11070
MA-1650-4 SERIES
Direct Character Entry Method
Using Flat Keyboard (installed as the ECR Main Keyboard):
-- Setting Mode Key Layout --
(Use the special template for this purpose and insert it between the film layers covering the Flat Keyboard. This
key layout is applicable to only certain submodes.)
Character Keys: Simply depress the key to enter the character. (The [#] key should not follow.) The
numerics 1 to 0 are entered as characters 1 to 0 but not as codes for PLU Item Codes, etc.
The One Double-size Declaration (by depressing [X] key once prior to the required
character) and the All Double-size Declaration (by depressing [X] twice before the
characters) are the same as in the CHARACTER CODE ENTRY method.
Function Keys: These are function keys to be used in programming operations with the Setting Mode Key
Layout. The Numeric Keys here are used to enter PLU Codes, etc. or numeric values as
program data, but not to enter the numerics as characters.
(Also, refer to “Case 2: When the ECR Keyboard is Flat Keyboard Type” already stated.)