- 130 -
EO3-11070
MA-1650-4 SERIES
➤
1 to 50 (see the table
on the next page.)
Repeat for other key codes.
➤
➤
➤
➤
*
* (For sequentially
programming key
codes, the key code
specification can be
skipped.)
Combination of Bit Nos 1 to 8;
enter 0 for all bits to RESET status;
see the table on the next page.)
KEY STATUS PROGRAMMING (Submode 23)
This submode programs the various selective statuses of media keys and other function keys.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
23 [X] |Key Code| [ST] |Bit Nos for SET status| [#] [AT/TL]
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-14-1994 MON #1
P23
#03 237
0054
ex.) To program the following key with the statuses listed below (refer to the KEY STATUS TABLE on the next
page).
KEY REQUIRED STATUS
[CHK TEND] Key Code 3
Bit
1: Follow Bit 2 (RESET)
2: TENDER only (SET)
3: Validation of Tender Amount (SET)
4: Short-tendering Allowed (RESET)
5: Over-tendering Allowed (RESET)
6: Sale Finalizing after [CHG TIP] Allowed (RESET)
7: No-purchase Cashing Allowed (SET)
8: Finalizing R/A Allowed (RESET)
Key Code 4
1: Validation Free (RESET)
2: Endorsement Compulsory (SET)
3: Drawer Open/Not-open: not applicable because the key is set as TENDER key
(RESET or SET)
4: Negative Check Free (RESET)
Operation
Mode Lock: SET, 23 [X]
3 [ST] (key code 3)
273 [#] (“SET” bit Nos)
4 [ST] (key code 4)
2 [#] (“SET” bit Nos)
[AT/TL] to complete submode.
To Next Page
Loading...
