- 159 -
EO3-11070
MA-1650-4 SERIES
Repeat for the next break entries (max. 10 breaks)
Pre-rounded Post-rounded
Value of the least Value
effective digit
00 to 24 00
25 to 74 50
75 to 99 100
Ignore in setting.
➤
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-14-1994 MON #1
P49
#1 2400
7450
0075
FOREIGN CURRENCY ROUNDING PROCESS SETTING, 2-digit type
(Submode 49)
This submode programs the rounding process of the sale paid in foreign currencies (tendered in foreign
currencies) and of the entries of No-sale Exchange from Domestic Currency to Foreign Currency. This submode
is applicable to the Foreign Currencies whose option “Special Rounding for Foreign Currency APPLIED 2 digits”
is selected in KEY STATUS PROGRAMMING (Submode 23) at Key Codes 46 to 50 (Bit 7 SET & Bit 8 SET).
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
Foreign Maximum Value of the
49 [X] Currency [ST] range of the digit [#] [AT/TL]
Key No. subject to rounding
NOTES: 1 When the “Post-rounded Value” is to be 100 (i.e., the final break point) the break entry is
automatically set (refer to the example below); therefore, it does not need to be entered. Entering
a value larger 99 for the Post-rounded Value will not cause an error. However, the rounding
process will occur only on the two least effective digits in sales entries.
2. A maximum of 10 breaks can be programmed.
ex.) To set following rounding table for the [CUR 1] key:
Repeat for other keys.
Post-rounded
Value
➤
➤
➤ ➤
1 to 5; 1 = [CUR1] ... 5 = [CUR5] 2 digit; 00 to 992 digits; 00 to 99
➤
Mode Lock: SET, 49 [X]
1 [ST] (Key No. for [CUR1])
2400 [#]
7450 [#]
[AT/TL]
To Next Page
Loading...
