- 39 -
EO3-11070
MA-1650-4 SERIES
* Code to designate Expansion Memory Capacity:
0: No Expansion Memory (i.e. with Standard Memory only)
1: 512KB
2: 1MB
3: 2MB
4: 3MB
5: 4MB
** Codes to designate System Setting (Combine the following four codes in a maximum of 4 digits. For example,
enter 12 to designate 1 and 2.):
1: Cashier Expansion Memory is used.
2: PLU Expansion Memory is used.
3: Check Track Expansion Memory is used.
4: CVS Spec. is used.
NOTES: 1. When no expansion memory is used, designation of the system setting is unavailable.
2. To use the CVS spec., the expansion memory of 2MB or more is necessary. Furthermore, when
the system setting code 4 (CVS spec.) is selected, all other system setting codes (1 to 3) are
forcibly programmed.
*** Values to be set for the Number of Cashiers, the Number of PLUs, the Number of Check Tracks, the Number
of Data Capture Records, and the Number of Negative Card Nos.:
Cashiers 15 1 to 15 1 to 99
PLUs 900 0 to 1,500 0 to 65,000
(NOTE 6 below)
Check Tracks 500 0 to 1,000 0 to 3,000
Data Capture 0 0 0 to 65,000
Records
Negative Check 0 0 0 to 3,000
Card Nos.
Item Default Value Value range when Value range when
(Number of:) (auto-set after a Standard Memory is Expansion Memory
RAM Clear) used is used
No setting for the Number of “Data Capture Records” and “Negative Check Card nos.” will be possible unless the
Expansion Memory is used.
NOTES: 1. The minimum unit for setting the number of PLUs, Check Tracks, or Data Capture Records or
Negative Check nos. is 100.
2. Even when a large area remains to be unallocated in the RAM, setting of any item cannot exceed
its value range specified in the table above.
3. When any of the values already set are to be changed even during the entire setting operation
sequence, complete the submode first by depressing the [AT/TL] key, then start the submode
again from the first after executing the Table Clear or the RAM Clear.
4. The Expansion Memory capacity must match the installed RAM capacity. When Check Tracks,
Data Capturing, or Negative of Card Nos is used, select the corresponding System Option
settings.
5. When using the Cashier Expansion memory, select the Code Entry Method.
6. For a system with the CVS spec. selected, value range with expansion memory used is 0 to
30,000.
To Next Page
Loading...
