TEC MA-1650-4 Series - Page 49

ADDRESS No. CONTENTS
BIT ITEM SELECTIVE STATUS STANDARD REMARKS
No. STATUS
SYSTEM OPTION TABLE
- 46 -
EO3-11070
MA-1650-4 SERIES
Standard Bit Set (auto-set by RAM Clear)
➤
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
1
2
3
4
5
6
7
8
15
5 SELECTIVE ITEMIZER CONTROL
SI1 Total Amount on
Receipt and Remote slip
on [SI1/TL] Depression
[SI1/TL] Key before
finalizing a sale
SI1 Function as Special
Discount (%- function)
SI1 Function as Special
Charge (%+ function)
SI2 Total Amount on
Receipt and Remote slip
on [SI2/TL] Depression
[SI2/TL] Key before
finalizing a sale
SI2 Function as Special
Discount (%- function)
SI2 Function as Special
Charge (%+ function)
PRINT (and DISPLAY)
NON-PRINT *
(DISPLAY only)
NOT COMPULSORY *
COMPULSORY
Follow Bit 4 status. *
%- (subtract from sale)
Not affect Sale Total *
%+ (add to sale)
PRINT (and DISPLAY)
NON-PRINT *
(DISPLAY only)
NOT COMPULSORY *
COMPULSORY
Follow Bit 8 status. *
%- (subtract from sale)
Not affect Sale Total *
%+ (add to sale)
Will print on Journal in
either status.
See NOTE 2 below.
The [SI1/TL] key depres-
sion will calculate and
finalize the SI1 content.
If both RESET, the SI1
content will not affect
sales total at all (only
display, print, or neither).
(If both SET, it will result
in %+ function.)
See NOTE 1 below.
Refer to Bit 1 to 4 de-
scriptions.
NOTE 1: If Bit No.3 SET is selected, the preset % rate (to be set in a separate programming operation described
later) will automatically subtract from the sale total.
If Bit No. 4 SET status is selected, the preset % rate will automatically add to the sale total.
If no preset % rate is set for the SI, 100% will be the rate (all SI amount).
If both Bit No. 3 and No. 4 are RESET, the following will display (and print if Bit No. 1 is SET) without
affecting the sale total:
• If % rate is preset, the amount calculated by the % rate.
• If % rate is not preset, the entire SI total amount (i.e. same as 100% preset).
NOTE 2: The SI 1 total amount will print disregarding the Bit No. 1 status selection when Bit No. 3 or No. 4 is SET.
(The same is applied to Bit No. 5 status selection as to SI 2 Total Print when Bit No. 7 or No. 8 is SET.)