EasyManua.ls Logo

TEC MA-1650-4 Series - Page 60

Default Icon
228 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ADDRESS No. CONTENTS
BIT ITEM SELECTIVE STATUS
STANDARD
REMARKS
No.
STATUS
SYSTEM OPTION TABLE
- 57 -
EO3-11070
MA-1650-4 SERIES
Standard Bit Set (auto-set by RAM Clear)
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
RESET
SET
1
2
3
4
5
6
7
8
1
27 DRAWER OPTION
Drawer-close Compulsory
Drawer Warning Alarm
Single-drawer or Multi-
drawer
Multi-drawer Control
Selection of Change at
Tendering in Foreign
Currencies
Number of Drawers (if
Multi-drawer spec.)
Number of Drawers (if
Multi-drawer spec.)
-- vacant --
NOT COMPULSORY
COMPULSORY *
NON-ACTIVE *
ACTIVE
SINGLE DRAWER *
MULTI DRAWERS
By Cashier *
By Currency
in Domestic Currency *
in Foreign Currency
Follow Bit 7 status. *
2 DRAWERS
Follow Bit 6 status. *
3 DRAWERS
*
NOTE 1 below.
NOTE 2 below.
NOTE 3 below.
The Bit 5 selection is
effective.
NOTE 4 below.
If both RESET:
1 DRAWER
If both SET:
4 DRAWERS
NOTE 1: If SET, the Drawer-close Compulsory option is ON. In that case, when the drawer remains open, any operation except [RF], [JF],
[VALIDATE], [C], numeric input for Sign-ON are prohibited. This rule is applied to REG, MGR, - , and LOCK modes; in other
modes and during a Pick Up operation, the drawer may remain open.
On V1.9 or after, even if SET atatus is selected, the operation of the [DISPLAY 6] key will be allowed while the drawer is open.
NOTE 2: This status selection is effective only when Bit 1 is SET. If SET (ACTIVE), the setting in DRAWER WARNING TIME operation
(Submode 38) will be effective. In that submode, a time value in seconds can be set for the time length with the drawer open until
the Warning Alarm generated (the initial value is 15 seconds).
NOTE 3: If SET, the Multi-drawer specification is selected.
In case of Cashier Code Entry Method (using [LOG] or [LOG/RECEIPT] key), a drawer is to be designated in sale entries, and
the number of drawers will be further selected at Bits 6 and 7.
In case of Cashier Key Method, the drawer to be used will be fixed as in the following:
Drawer 1 for Cashier 1, Drawer 2 for Cashier 2, Drawer 3 for Cashier 3, and Drawer 4 for Cashier 4 & all others.
NOTE 4: If RESET, both Drawers 1 and 2 will be opened to enable accesses to both Domestic and Foreign Currencies.
If SET, only Drawer 2 will be opened to enable an access to Foreign Currencies only.

Table of Contents

Related product manuals