- 74 -
EO3-11070
MA-1650-4 SERIES
1 [X]
| Line No. | [ST]
.
.
Submode No.
.
.
1 to 7
or (See NOTE 2 below.)
5 to 7
Character Entries
max. 24 characters/line
[ST]
.
.
To complete
this line
[AT/TL]
.
.
To complete this
programming
operation
Repeat for
another line.
(For sequentially
programming lines, the
line number specification
can be skipped.)
(See CHARACTER ENTRIES at
the beginning of this chapter.)
➤
➤
➤
➤
➤
➤
STORE NAME/MESSAGE AND COMMERCIAL MESSAGE
PROGRAMMING (Submode 1)
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
NOTES: 1. For each line, a maximum of 24 regular-sized characters or 12 double-sized characters may be
entered. A combination of both types is also available.
2. Even if the option “Store Name Print by RUBBER STAMP” is selected, data can be programmed
for the store name/message. However, the Rubber Stamp, instead of the programmed name/
message will actually be printed for operations to issue receipts.
If the option “Store Name Print by DOT PRINTER” is selected, use 1 through 4 for the store name/
message and 5 through 7 for the commercial message data, as Line No.
The range of Line Nos. 5 to 7 is unavailable to a manual-cut printer.
3. If no commercial message is required on the receipt, program blanks for all three lines. As a result
no extra lines will be fed. If any one of the three lines is programmed, the two other lines will cause
line feeds.
4. The 4-line range assigned for the store name/message will be either printed or fed, regardless
of any system option selection.
5. If any incorrect characters have been programmed, depress the [C] key to clear all the characters
on a line and then re-enter characters from the beginning, or end the line with an [ST] and re-
program the entire line. The new data will be active.
6. When all the lines have been programmed, do a check by issuing a receipt. Only the lines with
errors need to be re-programmed; other lines will not be affected.
To Next Page
Loading...
