TEC MA-1650-4 Series - Page 82

- 79 -
EO3-11070
MA-1650-4 SERIES
DEPARTMENT TABLE PROGRAMMING (Submode 3)
Programming
CONDITION To change the Positive/Negative Status:
After Department and PLU Daily and GT Resets
To change any other programmed data or to newly program departments:
Any time outside a sale
OPERATION Mode Lock: SET
EE
Submode No.
Repeat for any
address within
the same dept.
by re-entry for
correction.
(NOTE 3 ) .
Repeat for
other
departments.
[DEPT]
[DP#]
|Department Code|
3 [X] |Address Nos| [#]
(NOTE 1 on the next page.)
for sequential-coded Dept. only
(NOTE 2 on the next page.)As for details of each Address,
refer to the following pages.
Address 2: Department Name
2 [ST]
Address 1: Link Group
1 [ST]
Address 3: Preset Price
3 [ST]
Address 8: Low Amount Limit
8 [ST]
Address 9: Sub-link Dept. Code
9 [ST]
[ST]
[AT/TL] (to complete this submode)
Address 4: Status 1 Codes
4 [ST]
Address 5: Status 2 Codes
5 [ST]
Address 6: Tax Status
6 [ST]
|Major GP| |Minor GP| [#]
(01 to 10) (01 to 30)
Character Entries [ST]
max. 16 characters
|Price| [#]
(max. 6 digits)
|Status Code to ON| [#]
(max. 5 digits)
|Status Code to ON| [#]
(max. 6 digits)
|Low Amount to be locked out| [#]
(max. 7 digits)
Address 7: High Amount Limit
7 [ST]
|High Amount to be locked out| [#]
(max. 7 digits)
|Status Code to ON| [#]
(max. 4 digits)
|Sub-link Dept. Code| [#]
(1 to 99)