- 92 -
EO3-11070B
MA-1650-4 SERIES
Status Item Selective Status
Code OFF ON
1 Quantity Entry Optional Compulsory
(Applicable for V2.0 or after)
2 Net to S.I. 1 ? No Yes
3 Net to S.I. 2 ? No Yes
4 Food Stamp (or GST) Status? No Yes
5 Scale Entry Prohibited Compulsory
6 HI-CONE Status? No Yes
7 Lock or Unlock Unlock (in use) Lock (not in use)
8 Delete the PLU? No Yes
Address No. Description of Programming Contents
-- Continued --
4 Status 1 Selection
• Enter the Status Codes 1 to 7 whose status must be set to ON side. More than
one code may be entered. Enter 0 when none of the statuses should be set
to ON. However, the Scale-Compulsory Status (Code 5) and HI-CONE
Status (Code 6) cannot be combined for one PLU.
NOTES:
• When the Quantity Entry Compulsory Status (Code 1) is selected, the
quantity entry is always necessary for PLU item entry. However, if the
[PACK] or [3rd PRICE] key is depressed, this compulsory status will be
ignored.
• Net to S.I. 1, 2 ... Refer to the section of PRESET RATE SETTING FOR
SELECTIVE ITEMIZERS near the end of this chapter.
• The HI-CONE Status (Code 6) is effective only with the Scanning feature.
• The HI-CONE Status (Code 6) requires setting of the Whole Package
Quantity (Address 8).
• The Delete Status set is possible only when the PLU center file is
selected.
Setting Examples:
To set only Status 2 to ON .............. Enter 2 [#]
To set Statuses 2, 3, 5 to ON .......... Enter 235 [#]
To set none of statuses to ON ........ Enter 0 [#]
-- Continued on next page --
To Next Page
Loading...
