TEC MA-600-1 series - Page 179

4. PROGRAMMING OPERATIONS EO1-11155
4.16 Tax Table Programming
4-56
Type 3: % Rate only
2) Operation Flowchart
3) Example
Tax3 table below is set.
10% is applied to any sale amount.
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [↓] key
three times.
Depress the [4] or [Enter] key.
Depress the [↓] key twice.
Depress the [3] or [Enter] key.
The cursor is moved on to “4 RATE, LIMIT
AMOUNT”.
“4 RATE, LIMIT AMOUNT” is selected.
The cursor is moved on to “3 TAX TABLE”.
“3 TAX TABLE” is selected.
Depress the [↓] key twice.
Tax type which has already been
programmed is displayed.
(continued on the next page)
“4 RATE, LIMIT
AMOUNT
”
is selected.
Main Menu
“3 TAX TABLE” is
selected.
ECR is being outside a sale and in
SET
mode.
Depress
[
↓
]
three times then
[Enter]
.
Or Depress [4].
Depress
[
↓
]
twice then
[Enter]
.
Or Depress [3].
Input 3.
[Enter]
3: RATE (% rate only)
RATE is selected.
Input a tax rate.
Tax rate is entered.
(0.0001% to 99.9999%:
Use the [.] key if a decimal portion
is contained.
The fraction of the amount resulting from this %
rate calculation will be rounded off.)
[End]
Th
is setting is ended. A long receipt is issued
and the display returns to Main Menu screen.