27
[Removing the ARMREST UNIT]
1. Turn the arm height adjustable ring to raise it to the height
of 6 mm (max).
2. Remove the screw C for removal.
• Screw C: XTB3+8JFJK [0.39 - 0.59 N•m] (1)
Note for attaching and removing the ARMREST UNIT
• Use a driver bit (No. 2) or small type of monkey wrench, etc.
to remove the screw because of the narrow gap (max 25
mm) of the fixing screw part of the ARMREST UNIT.
Do the same when attaching. (See the fig. below.)
[Ref.] When using a commercially sold board ratchet driver
• Use a driver suitable for working in the gap of 25 mm.
6.9. MAIN PCB
Note when tightening the screw
• Be careful not to break the screw hole of the TOP PANEL.
Ref.) Turn it to the opposite side once, and align the screw
with the hole.
Then, tighten with forward rotation.
1. Remove the T/T RUBBER MAT and TURNTABLE UNIT.
(See 6.3. T/T RUBBER MAT, TURNTABLE UNIT, step1.)
2. Remove the INSULATORS.
(See 6.5. INSULATORS, step2 and 3.)
3. Remove the BOTTOM CHASSIS.
(See 6.6. BOTTOM CHASSIS, step3 and 4.)
4. Remove the couplers and screws for removal.
• Coupler: P2101, P2102, P2103, P3101, PA1001,
PB1002, PF1006, PH1008
• Screw: RHD30111-31 [0.8 - 1 N•m] (7)
To Next Page
Loading...
Need help?
General