Technifor XF510Cr User Manual

AOperating instructions for the machine
B
Ref. DCD01/3074 - XF510Cr-Sr-Dr_en_C
13/31
90° adapter
Column stand
Standard air filter
Start cycle foot pedal
Ref.: 52874
• Used to obtain an elbow output of the electric
connector.
XF510Cr:
Ref.: 58886
XF510Sr:
Ref.: 52866
XF510Dr:
Ref.: 58887
• Marking machine support with height adjustment
range of 333 mm (13.11 in).
• For the safety of the operator, the column base is
sold only with the protective shutter option.
• May lead to a loss of marking quality (gap).
• Cast iron table supports standard accessories or
specific tooling.
• A graduated ruler along the column indicates the
Z axis position of the marking head.
Ref.: 64994
• This filter comes equipped with a pressure gauge
for regulating air pressure. It eliminates impurities
in the compressed air system and reduces soiling
of the solenoid valves and stylus.
•
Use of this filter is mandatory if the air contains
particles (dust...) of greater than 40 µm.
Ref.: 52712
• Office footswitch:
A simple touch of the pedal will launch a marking "n"
times, leaving the operator with both hands free. The foot
pedal is not designed to stop marking.
Ref.: 52713
• Industrial footswitch:
Same use as described above. This foot pedal is
especially designed for industrial work environments or
for high rate production.

Technifor XF510Cr Specifications

General

Brand	Technifor
Model	XF510Cr
Category	Controller
Language	English