TechniSat DIGITRADIO 2 - Manual Setting

114
> Use the < or > buons to select the [Signal strength] item and press OK.
> Exit the menu by pressing the MENU buon several times.
> The display shows the signal strength using a bar graph.
Stations with a signal strength below the required minimum signal intensity
are not transmiing a strong enough signal. Align the telescopic antenna as
described in section 5.3.3 if required.
7.2.7 Manual seing
This menu item is used to check the reception channels and can be used to position the
antenna.
> Briefly press the MENU buon, use the < or > buons to select the [Set
manually] item and press the OK buon.
> Use the < or > and OK buons to select a channel (5A to 13F). The signal
strength will now be shown on the display. If a DAB+ station is being received
on a channel, the station ensemble name is displayed. The antenna can now be
aligned to the maximum signal intensity.