TechniSat DIGITRADIO 2

132
12.4 Factory seing
If you change the location of the device, e.g. when moving house, it is possible that
the saved stations can no longer be received. In this case you can reset the device to
factory seings to delete all the saved stations and then launch a new scan.
> Hold down the MENU buon and use the < or > buons to select the [Factory
seings] item. Press the OK buon.
> Using the < or > buons, select the [Yes] item to reset to the factory seing and
press the OK buon.
All previously stored stations and seings will now be deleted. The device is now
in the same status as when delivered.
> The display will show [Restart ...] and the device will start with the language
selection [Language]. Select one of the available languages using the < or >
buons and confirm the selection by pressing the OK buon. Subsequently, the
device performs a channel search in DAB+ mode. While scanning, the display
information shows the progress as well as the number of digital radio stations
detected. Aer completing the station scan the first DAB+ channel is played.